May 12, 2010 · Anyone use the Napa "block tester" for coolant leak test? Jump to Latest 21K views 4 replies 3 participants last post by pnut333 May 13, 2010 P

Nov 6, 2015 · A good way to test block heaters is to test how much current they draw. You could use a standard multimeter in series to get an amp measurement, but they're usually limited to 10 amps. A …

Jan 16, 2007 · The block was a used block I bought that had just been rebuilt within 1 year (Or so I was told) it had been bored out to .040 with new rings and pistions installed (my old block devoloped a …

Jun 24, 2004 · I have a small block 350 in my '77 FJ40 and I'm using the SAE to NPT adapter so I can use the OEM sender with the OEM gauges. The wire going from the circular dash plug going through …

Jan 5, 2011 · I do need to up my return to -8 and I have 2 block 90 fittings on the ram that need to be removed. I dont expect either of those to make a huge difference but they are the changes I am …

Mar 31, 2011 · GMC/Eaton 2.5 Ton axles - starting a new build down here in Brazil Hey guys I know it sounds and also looks hillbilly but I'm starting to build my F-100 Flat Bed as a mud truck/trail rig, got …

Jun 12, 2018 · I believe the long block is original to the vehicle. I wanted to run a compression test just for the information not because anything was obviously wrong. I ran the test cold without warming …

Dec 3, 2005 · I just got a Samurai from a buddy for 300 bucks and I was wondering what is the cheapest lift that I can get....I don't want anything huge just like 2 or 3...

May 24, 2012 · Is there a special tool to remove wires from the back of a fuse panel? I have an aftermarket wiring harness (previous owner purchase) that has WAY too many circuits for this …

May 14, 2017 · One trick on the block test I've found is to drain most of the coolant out and fill it with water. Run the engine hard with the cap off till shit shoots out then put the tester in there after it …